Problema skimmer ?

This message was edited 1 time. Last update was at 15/01/2019 17:31:14

Salutare,

Am o mica problema (urata problema) cu skimmerul. Este un Tunze 9004 stock. Este in display, nu am sump.
Il am in functiune de peste o luna, dar in continuare imi scoate microbule, majoritatea in partea de jos. Scoate si pe laterale, dar foarte putine (neglijabil).
Cum as putea sa scap de fenomenul asta ? Am tot cautat pe net, am facut tot ce am gasit (pornit cu aerul full deschis, apoi reglat de acolo, asteptat o sapt sa faca pelicula pe interior, etc) .
Ma dispera, si strica tot displayul, plus ca bulele de aer dupa 3-4 zile se aduna pe suprafata in colturile unde flow-ul este mic si formeaza pelicula.

Mersi, Lucian.

This message was edited 1 time. Last update was at 15/01/2019 17:35:11

citat din manual:

Bubble formation at the output of the
skimmer

During operation of the skimmer in the start-up phase and during the feeding of the animals it is possible that fine air bubbles are discharged at the outlet (4). These air bubbles are created when the aquarium biotope is oversaturated with oxygen, and also after the addition of nutrients and organic supplies, amino acid, etc. Even if a filter wool is used which is not prewashed the water can be very foamy, and the Comline® DOC skimmer can possibly overflow and definitely produce many small air bubbles.

This bubble formation usually isn’t harmful to animals.

However, we recommend to always use the full air power, and to position the unit slightly higher within the aquarium in case of an excessive foam development.

If the fine air bubbles are bothersome, the foam insert 3162.200 can be installed at the bottom of the skimmer (5).
The bubble formation will usually disappear by itself after the start-up phase or within a few days.

deci
1. aer la maxim
2. pus cat mai sus posibil
3. burete pus sub el, in locasul ala special de sub pompa
4. probabil o sa treaca, cu rabdare

si mie mi s-a parut destul de fitos acest skimmer, mi-a luat niste luni de bibileala ca sa ma inteleg cu el

Pe full air mi-a umplut cupa pana acum in cateva zeci de minute. Incerc sa-l ridic (asta n-am incercat) si eventual ii pun si burete .
Mersi

revin cu rezultate

da, ridica-l sus sus de tot, eu l-am pus f sus, mai sus decat mi se parea ca va functiona, dar cumva tot isi trage apa

chiar sunt curios daca va fi vreo imbunatatire

This message was edited 1 time. Last update was at 15/01/2019 18:00:21

in prima faza au scazut bulele(tot mai sunt, dar mult mai putine), dar se tot umple cupa cu apa
sa vad cat ii ia, poate incepe sa skimeze normal si nu mai arunca apa pe sus.

A mers perfect treaba cu ridicatul! Skimeaza normal si nu mai scoate bule.
Mersi mult !!

super, cu placere!